User GuideOricom PMR888 UHF Two-Way Radios
UHF Channels and frequenciesAlertsChannel busy indicatorThe red LED will flash twice per second to indicatethat the channel is in use.Call tonePress t
10.*Repeater access channelsUsing the optional value-pluscharge kitUsing the optional twin charging pod (not included)Charging podTo use the charging
Ordering the optional value-pluscharge kit5. Slide the radios into the charging pod ensuring the charging contacts line up. The red light on the charg
12.The kit is available at a cost of $59.00*Contact Oricom on:1300 889 785 or visit www.oricom.com.auPayment can be made by Mastercard, Bankcardor Vis
Contact usAustraliaOricom International Pty LtdLocked Bag 658South Windsor NSW 2756AustraliaCustomer supportEmail: [email protected]: www.orico
Stay in touch for FREE with OricomHighly sophisticated: You can communicate when you’re around the home, out and about enjoying sportand leisure activ
AntennaPTTOn/Off/Volume controlMicrophoneSpeakerMenu downMenu upDisplayMonitorVOX accessory socketCall toneModeYour Oricom PMR888 radio controls1.
Complies with all relevant Australian and New Zealand approval requirements including radio communications(Electronmagnetic Radiation Human Exposure)
Safety and general informationExposure to Radio Frequency (RF) energyYour radio contains both a receiver and transmitter.When it is turned on it recei
Installing the batteriesEach radio uses one Ni-Mh rechargeable batterypack (not supplied). Or three AA alkaline batteries(not supplied).Warnings• Do n
Using your Oricom PMR888Turning your radio on and offTurn the volume button clockwise to turn your radioon. The radio chirps and the display will brie
2. Press and hold “PTT” and speak into the microphone. The LED indicator light glows continuously when transmitting.3. To receive messages, release “P
You can specify a different code for each channel.1. To set a channel and code combination, press once and then press or to select the channel.2. Pr
Select call tone1. With the radio on, press three times until “C” appears in the display.2. Current call tone setting will begin to flash.3. Press
Comments to this Manuals