Baby MonitorSecure 100User Guide
8 BASIC OPERATIONOnce you have set up your Baby Monitor, you will be able to hear the sounds in your baby's room through the Parent Unit. And als
9BASIC OPERATION• To stop the Page alert, press any button on the Parent Unit, or press [ ] again on the Baby Unit.Note: If no button is pressed, t
10 BASIC OPERATION8 lights illuminated fully charged6 lights illuminated half charged4 lights illuminated battery is running low2 lights illumina
11TROUBLESHOOTINGProblem Possible cause(s)The red power lights do not turn on when you plug in the power.1. Check if the units are properly connected
12 PRODUCT SPECIFICATIONSFeature Specifi cationsOperating Frequency DECT 1.8 GHzRangeUp to 300m under optimum conditions. The range is reduced in build
13GUARANTEEWarranty (Australia)(a) Warranty Oricom International Pty Ltd (Oricom) warrants that the product is free from defects in materials and wor
AustraliaOricom International Pty LtdLocked Bag 658South Windsor, NSW 2756Customer SupportEmail: [email protected]: www.oricom.com.auPhone: 130
TABLE OF CONTENTSWARNINGS AND SAFETY INFORMATION 1GETTING STARTED 3YOUR BABY MONITOR 5BASIC OPERATION 8TROUBLESHOOTING 11PRODUCT SPECIFICATIONS
1WARNINGS AND SAFETY INFORMATIONIMPORTANTPlease read this user guide thoroughly before use.Your ORICOM Baby Monitor is designed to be an aid and shoul
2 WARNINGS AND SAFETY INFORMATIONBattery requirementsEach parent unit requires two rechargeable Ni-MH batteries, size AAA 1.2V 800mAh (HR10/44).• Do
3InstallationFor the Parent Unit1 Remove the Belt Clip by lifting the clip at the top and sliding it downwards.2 Then remove the battery cover on th
45 Press [ ] to turn the Parent Unit on. • Before fi rst use, or if it has been out of use for a long time, the Parent Unit will need to be charged
5YOUR BABY MONITORBaby unit (Sender)1 Night light Key Press to turn On the night light. Press again to turn off the Light.2 Power On/Off Key Pres
6 YOUR BABY MONITORLeft view of baby unit6 DC 6V input Connecting to Power Adaptor.789106Parent unit (Receiver)7 Battery Cover Rechargeable batterie
7Charger Pod14 Charging Light When Parent unit is placed in the Charger Pod, the red charger light comes ON to indicate the batteries are charging. L
Comments to this Manuals