Oricom PMR1200 User Manual download pdf (Page 10)

Getting Started

Battery meter

The battery meter is located in the left corner of the LCD screen.

It appears like a battery with three bars inside. These indicate

the amount of power available. When the battery level reaches it

minimum level, the unit will emit two beep tones and automatically

it will power off.

Your PMR1200 can detect the battery charge in 4 levels;

Battery charge at high level.

Battery charge at medium level.

Battery charge at low level. At this level, the radio will emit

a “beep” sound for every 10 seconds in standby mode.

TIP: At this stage, you need to recharge the unit at

once, otherwise the battery will run down totally.

Battery charge at very low level. When the battery level

reaches its minimum level, the unit will emit two beep tones

and automatically turn off the power.

Important: You need to charge the unit for 10-14 hours.

CAUTION: Risk of explosion if battery is replaced by

an incorrect type. Dispose of used batteries

according to the instructions.

f. Charging the battery pack (using adaptor)

Lift the charge socket cover located on

the right side of the handset.

Insert the round connector of the 9.0V

DC/200mA adaptor into the charge jack.

Plug the mains adaptor into a 240V AC,

50Hz main socket with the switch on the

socket set to OFF.

Then switch ON the main socket.

Mic/spk jack

Charge jack

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 27 28

No comments

Oricom PMR1200 User Manual Page 10