Oricom PMR1200 User Manual download pdf (Page 9)

Getting Started

Charging the battery pack

a. Insert the small plug in the end of the mains adaptor into the Power-in

Connection Jack at the back of the desktop charger.

b. Plug the mains adaptor into a 240V AC, 50Hz main socket with the switch on

the socket set to OFF.

c. Switch ON the main socket.

The radio must be charged using the mains adaptor provided. Using any

other adaptor will invalidate any approvals & warranty.

d. Place the radio units in the charge cradle in an upright position and facing

outward. The Charge LED indicators will light up.

e. It takes about 10 hours to fully recharge the batteries if the battery are

completely run down. New batteries take up to 14 hours to fully charge.

Important

Read these Safety Warnings before you charge the

batteries.

When placing the radio in the charger, use only the power

supplies listed in the user instructions supplied with the unit.

Don’t try to recharge non-rechargeable batteries.

Make sure the battery compartment cover is securely

locked in place when you are charging the batteries.

Dispose of used batteries safely and in a way that will not

harm the environment- never try to burn them or put them

anywhere, they could get burnt or punctured.

Don’t leave dead batteries in your radio.

They might leak if you do.

Main socket

Important:

Always turn off the radio units when charging.

This will shorten the charging time.

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 27 28

No comments

Oricom PMR1200 User Manual Page 9